DOWNLOADS
ALL DOWNLOADS AT A GLANCE

IMAGEBROCHURE

Stationary GAS ANALYSIS

Mobile
GAS ANALYSIS

DESULFURISATION

FLOW MEASUREMENT

LAB FACILITIES

Service

Software
IMAGEBROCHURE
GAS ANALYSIS
- Technical data AwiECO
- Technical data AwiFLEX
- Instructions AwiECO Part A
- Instructions AwiECO Part B
- Instructions AwiEFLEX Part A
- Instructions AwiFLEX Part B
- Instructions AwiFLEX XL Part A
- Instructions AwiFLEX XL Part B
- Instructions bus connection
- AwiView 2.0 instructions data evaluation instruction
- AwiView 2.0 quick instructions data evaluation instruction
MOBILE GAS ANALYSIS
INSTALLATION NOTE
The latest firmware for the Awi2GO can be downloaded to the Awite USB stick and will be installed automatically after inserting it into the Awi2GO and switching the device on. The software update is cumulative and should be installed on all devices.
Changelog V.1.0.28
- Backup message: Spelling mistake in the backup message corrected.
- Data transfer: Fixed incorrect display of device number when attempting to transfer with an incompatible device number.
Changelog Archiv
Changelog V.1.0.27
- Backups from devices with more than 2000 measured values could not be restored. For devices with large amounts of data, an error message also appeared if the USB stick was inserted before switching on, because communication with the sensors is interrupted during data transfer.
- V1.0.27 for devices with SN: 08316-00037 to 00041; 08317-00076 to 00085; 08318 - not affected
Changelog V.1.0.18
- Calibration date was displayed for each individual sensor instead of just once at the top level (when a total calibration was performed). Time display layout optimised (hours too far to the left with narrow numbers ‘11’, now HH MM SS right-aligned/centred/left-aligned. Text field for sensor serial number and backup information extended (text content was truncated depending on the number combination because the text field was too short).
- V1.0.18 for devices with SN: 08316-00032 to 00036; 08317-00063 to 00075; 08318 - not affected
Changelog V.1.0.15
- Pump monitoring: required pressure difference changed from 1 mbar to 0.2 mbar (otherwise error message in case of negative pressure)
- V1.0.15 for devices with SN: 08316- not affected; 08317-00038 to 00062; 08318 - not affected
Changelog V.1.0.9
- Restore configuration: Measuring points were not read in
- V.1.0.9 for devices with SN: 08316-00025 to 00031; 08317- not affected; 08318-0001 to 00018